To reset your router to the factory default settings, you can Press and Hold the Reset button on your router. However, in some cases, this may not successfully reset the router to the default status. ASUS recommends that you try the Hard Factory Reset before attempting any advanced troubleshooting. The methods to do a Hard Factory Reset will vary between different router models. Re: Build 53 bricked Asus RT-N10. Joe Lee 28 Nov 2010, 22:21. To flash using the 'recovery' method, do the following. Unplug the router. Press and hold the restore switch and plug in power. Keep holding the restore switch until the power light starts to blink on and off. #3) Hold Reset Button while powering up #4) Power on router #5) Hold Reset Button until the Power light blinks on-and-off slowly #6) The router is now in recovery mode #7) Open 192.168.1.1 in your browser #8) Upload firmware OP posted above Upgrade took about 60 seconds and it then asked me to reboot.
Here you can find the default IP address and the username and password for the user interface of the ASUS RT-N10 Wireless-N150 router. This site also contains information about the preconfigured Wi-Fi settings of the device. In the bottom part of this website, you will find a manual for accessing the user interface of this router and resetting its factory settings.
Login data for the user interface
Reset Router Asus Rt-n10
Preconfigured Wi-Fi settings
Asus Rt-n10 Hard Reset
Access to the user interface
Accessing the user interface is necessary when you want to change the router configuration. For the ASUS RT-N10, you have to do the following steps for access:
- Switch on router
- Establish a connection between the device and the router via network cable or Wi-Fi*
- Start web browser
- Enter IP address in the address bar and then confirm with ‘Enter’ key
- Enter username and password in the open interface and confirm once more
* Make sure that your router’s Wi-Fi is activated.
Reset default settings
Resetting default settings is especially helpful when you have changed and forgotten the login data for the user interface. Please consider that not only will settings like IP address, username and password be set to factory settings, but all configurations you may have made will as well.
Execute hardware reset
To reset the ASUS RT-N10 to its default settings, you have to do the following steps:
- Switch on router
- For at least 6 seconds, press the Restore button
- Device restarts automatically
- Router has been reset to factory settings
Execute software reset
Asus Rt-n10 Reset Factory Defaults
With the ASUS RT-N10, you can restore the factory settings with the installed software. Log in to the user interface of the router with your access data and execute the steps that are described in the user handbook.
Asus Rt-n10 Reset
After you have successfully executed the steps mentioned above, the configuration of the router will be reset to factory settings. If you want to log in to the user interface, you have to use the preset login data.